11 66 000 Removing and installing/replacing vacuum pump (N55)
Special tools required:
Necessary preliminary tasks:
- Remove DRIVE BELT .
- Remove TENSIONER for drive belt.
- Remove SEALING COVER for vacuum pump.
- Remove SEALING CAP of chain tensioner for oil pump.
- Remove HIGH PRESSURE PUMP .
- Disconnect vacuum line from vacuum pump.
Unlock connector (1) on vacuum pump and disconnect.
Rotate crankshaft at central bolt.
Turn sprocket wheel until drilled holes and screws of vacuum pump match up.
Screw in special tool 11 8 650 .
Secure special tool 11 0 290 in sprocket and to special tool 11 8 650 .
Release screw (1).
Tightening torque 11 66 2AZ .
Carefully press tensioning rail (1) with a suitable screwdriver (2) in direction of arrow.
As the oil pressure in the chain tensioner can only be drained pulsating, the tensioning rail (1) must be pressed several times.
Press the tensioning rail (1) and hold down.
Fix chain tensioner piston in position with a suitable lock pin (2).
Release screws (1).
Tightening torque 11 66 1AZ .
Release screws (1).
Secure screws (1) against falling out.
Remove vacuum pump (1) in direction of arrow.
Installation note:
Replace seal.
Assemble engine.