51 34 420 Removing and installing/replacing cover on window frame of rear door (front), left or right
Necessary preliminary tasks:
- Open rear side window
- Detach COVER ON DOOR WINDOW FRAME in B-pillar area.
- Remove INNER WEATHER STRIP
- Remove OUTER WEATHER STRIP
IMPORTANT:
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
Detach rubber seal (1) and rubber window seal (2) from cover.
Installation note:
Coat rubber seal (1) and rubber window seal (2) with APPROVED LUBRICANT before mounting.
Make sure rubber seal (1) and rubber window seal (2) are correctly seated on cover.
Release screws (1).
Carefully detach trim (2) towards front/top.
Installation note:
Fitted foam parts must not be damaged when cover (2) is pushed in.