67 62 020 Removing and installing/replacing flat motor for rear left or right power window regulator

Necessary preliminary tasks:

Release screw connections (1).

Remove flat motor (2) from power window regulator.

Cable must not come loose from power window.

Installation note:

Simultaneously tighten both screw connections (1).

The shaft of the flat motor (2) must be pulled into the holder of the power window regulator under slight tension.

Tightening torque 51 35 1AZ .

Fig 1: Identifying Power Window Regulator Motor And Screw Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Flat motor (2) must engage exactly at the marked points of the power window regulator (1).

IMPORTANT: Ensure that the flat motor (2) is assembled without tension.

Fig 2: Locating Power Window Regulator Motor Mark Points

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

Read and comply with NOTES on initialization of power window regulator.