Removing both actuators
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING BOTH WIPER ARMS .
- Refer to REMOVING COWL PANEL COVER .
- Refer to REMOVING THE SOUND INSULATION ON THE FIREWALL UPPER PART AT THE CENTER .
- Refer to REMOVING ACOUSTIC COVER AT REAR .
- Refer to REMOVING THE RIGHT ENGINE BULKHEAD .
- Refer to REMOVING THE PARTITION WALL ATTACHMENT PART .
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
NOTE:
The figure shows the rear of the engine.
- Position special tool 2 360 895
correctly on the actuator (1) of the intake side.
- Turn the intake side actuator (1) with the special tool 2 360 895 by approx. 50° in the arrow direction and release it.
NOTE:
The figure shows the rear of the engine.
- Position special tool 2 360 895
correctly on the actuator (1) of the exhaust side.
- Turn the exhaust side actuator (1) with the special tool 2 360 895 by approx. 50° in the arrow direction and release.
NOTE:
The figure shows the rear of the engine.
- Unlock both plug connections (1) and disconnect.
- Feed out and remove both actuators.