Installing the holder for the DME control unit
- Install the holder (2) for the DME control unit.
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| DME control unit holder on strut tower | ||
| Tightening torque | 2.5 Nm | |
Follow-up work
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .