Installing the rear spoiler
- Check the rear spoiler.
Do not install rear spoilers with poor fitting accuracy.
A rear spoiler loosely placed on the tailgate must not protrude, especially at the corners.
- Transfer the mid-centring (1) via adhesive tape to the outer side of the rear spoiler.CONSUMABLE DESCRIPTION
Yellow plastic adhesive tape 83199410979 - Place the rear spoiler (1) on the tailgate and align to the adhesive tapes and the tailgate edge in the center.
- Check whether the rear spoiler (1) fits correctly and is in the center.
- Clean the bonding surface of the tailgate.CONSUMABLE DESCRIPTION
Cleaning agent R2 500 ml 83190417324 TECHNICAL DATA SPECIFICATION (2' Series coupe and convertible, 2017-2021)Air drying time after cleaning Cleaning agent R2 2 min - Pull off protective film (2) from the bonding surface, align rear spoiler (1) as shown and stick to the tailgate.
Press down on the rear spoiler (1) with force using the hands over the entire area, in particular at the edges.
NOTE: The adhesion of the adhesive tape builds up significantly via the contact pressure.
Therefore, press thumbs or fingers over the entire area.- Remove the adhesive tape.