11 65 Turbocharger and Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Exhaust turbocharger to cylinder head | N20/N26 | M7 | Replace flange nut. | 13 Nm |
| 2AZ Heat shield/retaining plate to crankcase upper part | N20/N26 | M6 x 16 | 10 Nm | |
| 3AZ Pressure converter (EPDW) to cylinder head. | N20/N26 | M6 x 16 | 10 Nm | |
| 4AZ Vacuum unit (wastegate valve) on exhaust turbocharger (N20). Electric wastegate actuator on exhaust turbocharger (N20/N26). |
N20/N26 | M8 | 20 Nm | |
| 5AZ Heat shield to cylinder head | N20/N26 | M8x16 | 19 Nm | |
| 6AZ Blow-off valve to exhaust turbocharger | N20/N26 | M6x14 | 10 Nm |