11 41 Oil pump with strainer and motor
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - OIL PUMP WITH STRAINER AND MOTOR
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Intake pipe on oil pump housing | N20/N26 | M6 | 10 Nm | |
| 2AZ Counterbalance shafts module to bedplate | N20/N26 | M8x75/M8x40 | Jointing torque Angle of rotation |
19 Nm 90 ° |
| 3AZ Chain module to crankcase and oil pump | N20/N26 | M6x30 | 10 Nm | |
| 4AZ Hydraulic valve of oil pump to crankcase | N20/N26 | M6x14 | 10 Nm | |
| 5AZ Camshaft sprocket to counterbalance shaft | N20/N26 | M10x30 | Replace screw Jointing torque |
20 Nm 95 Nm |
| 6AZ Counterbalance shafts module to bedplate | N20/N26 | M6x25 | 10 Nm | |
| 7AZ Oil pump to counterbalance shaft housing | N20/N26 | M6x70 | 10 Nm |