11 62 Exhaust manifold
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - EXHAUST MANIFOLD
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Exhaust manifold to cylinder head Coat screw connections with CRC copper paste | All | M6 | Replace nuts | 10 Nm |
| M50/M52/M52TU/M54/M56/S52/S50 US | M7 | Replace nuts | 20 Nm | |
| All/others | M7 | Replace nuts | 15 Nm | |
| M10 | M8 | Upper row of staybolts installed with bolt cement | 23 Nm | |
| M21 | M8 | Replace nuts Retighten after 2000 km Slacken nuts by a 1/4 turn | 12 Nm 12 Nm | |
| M41/M47/M47TU/M51/M57/M57TU | M8 | Replace nuts | 20 Nm | |
| All/others | M8 | Replace nuts | 23 Nm |