11 11 Engine block
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - ENGINE BLOCK
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Main bearing bolts (steel bolts 10.9) | N20/N26 | M10x100 | Renew screws. | |
| 1. Jointing torque | 5 Nm | |||
| 2. Tightening torque | 20 Nm | |||
| 3. Angle of rotation | 90 ° | |||
| 4. Angle of rotation | 90 ° | |||
| 2AZ Screws on the crankcase lower section to upper part. | N20/N26 | M8x30 M8x40 | ||
| 1. Jointing torque | 5 Nm | |||
| 2. Tightening torque | 22 Nm | |||
| 3. Set final torque, sealing compound | 22 Nm | |||
| 3AZ Oil spray nozzles to engine block | N20/N26 | Hollow bolt | 12 Nm | |
| 4AZ Screw plug for upper part of gear case | N20/N26 | M22x1.5 | Replace screw with sealing ring. | 50 Nm |