18 31 Exhaust pipe with catalytic converter/complete system
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - EXHAUST PIPE WITH CATALYTIC CONVERTER/COMPLETE SYSTEM
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Exhaust system to catalytic converter | N20 | M8 | 24 Nm | |
| 2AZ Catalytic converter to turbocharger | N20 | M8 | Replace clamp | 13 Nm |
| 3AZ Exhaust system to rear axle final drive | N20 | M12 | 35 Nm | |
| 4AZ Clamp | N20 | 45 Nm | ||
| 5AZ Exhaust system to body | N20 | M8 | 21 Nm | |
| 6AZ Exhaust system on transmission cross-member | N20 | M8 | 21 Nm | |
| 7AZ Exhaust system on rubber mount | N20 | M8 | 21 Nm |