11 22 500 Removing and installing/replacing flywheel (N20)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks:
- Remove transmission See 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) N20 or 23 00 017 REMOVING AND INSTALLING TRANSMISSION (GS6-17BG) N20 .
- Remove CLUTCH
Automatic transmission:
Secure flywheel (1) with special tool 11 9 260 .
Unfasten flywheel bolts.
Tightening torque 11 22 1AZ .
Installation note:
Flywheel (1) is secured with an dowel pin.
Clean all threads for flywheel bolts in crankshaft.
Fit new flywheel bolts.
Manual gearbox:
Fasten dual-mass flywheel with special tool 11 9 260 .
Release flywheel bolts with special tool 11 4 180 /
Tightening torque 11 22 2AZ .
Installation note:
Flywheel is secured with a dowel pin.
Fit new flywheel bolts.
Clean all threads for flywheel bolts in crankshaft.
Installation note:
Pay attention to dowel pin.
Installation note:
Ensure installed position of magnet wheel is correct.
Assemble engine.