22 11 011 Replacing left engine mount (N20)

Necessary preliminary tasks: 

• Secure engine in INSTALLATION POSITION .
• Remove underbody protection at front and rear. See REMOVING FRONT UNDERBODY PROTECTION and REMOVING REAR UNDERBODY PROTECTION .

Release screws (1).

Tightening torque 22 11 1AZ .

Remove engine mount.

Fig 1: Identifying Engine Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Rubber part (1) of engine mount must point to center of vehicle.

Engine mount identification:

Right engine mount

• Even component number

Left engine mount

• Odd component number

Fig 2: Identifying Engine Mount Rubber Section

Courtesy of BMW OF NORTH AMERICA, INC.