24 30 Hydraulic/electric control parts and controlling elements (1 of 2)
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - HYDRAULIC/ELECTRIC CONTROL PARTS AND CONTROLLING ELEMENTS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Valve body to transmission | GA6HP19TU/GA6HP26TU | M6 | 8 Nm | |
| 2AZ Valve housing to valve body | GA6HP19Z/GA6HP26Z/GA6HP32Z | M6 | 5 Nm | |
| 3AZ Input- and output-speed sensors to mechatronics | M6 | 12 Nm | ||
| 4AZ Mechatronics to transmission | GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z/GA8P70H | M6x59, M6x20 | Replace screws | 8 Nm |
| 5AZ Oil volume accumulator to transmission | GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z | M6x59, M6x20 | Replace screws | 8 Nm |
| 6AZ Centering plate to transmission bell housing | GA8HP45Z/GA8HP50Z/GA8HP70Z/GA8HP75Z/GA8HP90Z | M8X74 | Jointing torque Angle of rotation | 10 Nm 90 ° |
| 7AZ Speed sensor to transmission | GA8HP50Z/GA8HP75Z | M6X20 | Replace screws Jointing torque Angle of rotation |
4 Nm 12 ° |