24 30 101 Replacing oil accumulator (GA8HP45Z)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapours.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT:
Applicable to vehicles from 08/2011
Remove transmission oil sump only after it has cooled down.
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Remove transmission oil sump only after it has cooled down.
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Installation note:
The transmission oil sump must be renewed every time it is removed.
IMPORTANT:
When the hydraulic impulse storage is exchanged, the spring can be relaxed in pulses due to a mechanical fault in the hydraulic impulse storage, resulting in a sudden escape of oil.
Necessary preliminary work:
- REMOVE TRANSMISSION OIL SUMP .
- Remove retaining plates.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.
Release screws (1) (M6x20).
Release screw (2) (M6x59).
Tightening torque 24 30 5AZ .
Carefully unlock connector (3) with screwdriver.
Carefully pull out oil accumulator.
IMPORTANT:
Mounting bolts of oil accumulator must
be replaced after removal.