24 13 015 Replace radial shaft seal for output flange (GA8HP45Z)
Special tools required:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapours.
- Wear protective gloves.
- Ensure adequate ventilation
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove rear underbody protection .
- Remove complete EXHAUST SYSTEM .
- Support transmission with lifter.
- Remove TRANSMISSION CROSS MEMBER .
- Partially remove PROPELLER SHAFT
.
- Disconnect propeller shaft at transmission.
- Release centre mount.
- Tie up propeller shaft to underbody.IMPORTANT: Bending the propeller shaft by an excessive angle can cause premature damage to the joint/propeller shaft!
Release transmission support block from transmission.
Tightening torque 22 32 2AZ .
Grip output flange (1) with special tool 23 0 020 .
Release nut with special tool 24 2 380 .
Tightening torque 24 13 2AZ .
Installation note:
Renew inner radial shaft seal
Renew output flange
Replace nut and secure with a mandrel (8 mm) by caulking.
Detach output flange from output shaft.
Remove spacer.
Attach special tool 24 2 353 to output shaft (1).
Screw in special tool 24 2 351 until it is firmly connected with radial shaft seal.
Pull out radial shaft seal by screwing in special tool 24 2 352 .
Oil sealing lip on radial shaft seal (1).
Drive in radial shaft seal (1) with special tool 24 2 370 and adapter ring 24 2 410 as far as it will go.