119510 Device AM

WARNING: This page is about a different variant/trim than selected.

NOTE: For mounting the radial shaft seal of the crankshaft, front.

Consisting of:

1 = 0495472 Basic body

image not available

2 = 0495473 Screw

NOTE: (screws (2 x))

3 = 0495474 Holding sleeve

NOTE: (Sliding sleeve)

4 = 0495475 Holding sleeve

NOTE: (Pressure sleeve) Can no longer be ordered separately. Only available as part of set 11 5 330 = 83 30 0 495 127.

5 = 0495476 Nut

NOTE: (Nut with bearing) Can no longer be ordered separately. Only available as part of set 31 2 120 = 83 30 0 491 909.