11 61 365 Removing and installing/replacing left-hand charge air duct (N20)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove INTAKE SILENCER HOUSING .
Remove UNDERBODY PROTECTION

Unlocked
Locked

Installation note:

Ensure locking clamps are correctly fitted.

Lock must engage.

Fig 1: Identifying Charge Air Duct Clamps

G09846240

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock snap fastener (2 and 3).

Remove charge air duct.

Fig 2: Identifying Throttle Body, Snap Fastener And Plug Connection

G09925120

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Visually inspect the form sealing ring (1) for correct position and damage.

VDA couplings are correctly fitted when they snap into place with an audible click.

Fig 3: Identifying Charge-Air Duct Sealing Ring

G09925184

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock snap fastener (1).

Installation note:

The snap fastener (1) must snap audibly into place!

Fig 4: Identifying Snap Fastener

G11086905

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Visually inspect the form sealing ring (1) for correct position and damage.

VDA couplings are correctly fitted when they snap into place with an audible click.

Fig 5: Identifying Sealing Ring

G09925192

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.