00..... Raising vehicle with trolley jack

Observe the following trolley-jack-related instructions: 

1. Only trolley jacks sold or approved by BMW, with a rubber plate on their mounting, may be used!
2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
3. Check the rubber plate on the trolley jack prior to each use, replacing if necessary.

Fig 1: Identifying Trolley Jack With Rubber Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Rear Differential With Car Jacking Points

Courtesy of BMW OF NORTH AMERICA, INC.

1. Car jacking point
2. Side car jacking points
3. Rear axle differential (REMOVE HEAT SHIELD )
   NOTE: It is not permitted to raise the vehicle at the rear differential cover!
4. Bolting point for rear axle trailing links

Risk of damage! 

Jacking point (1) must be present!

Align the rubber plate on the trolley jack to the jacking point (1) in such a way that there is no contact to adjacent components and that they are therefore not damaged.

Fig 3: Identifying Car Jacking Points

Courtesy of BMW OF NORTH AMERICA, INC.