17 21 500 Flush gearbox oil cooler and lines (automatic transmission)
Special tools required:
- Installing a new or replacement transmission.
Procedure:
(With automatic transmission REMOVED ).
Connect appropriate adapters (see description below) to oil lines exiting from automatic transmission.
Use quick-release coupling to connecting line 17 2 019 from oil dispenser unit.
Use quick-release coupling to drain line 17 2 018 .
Hold and direct open end of drain line into a suitable collecting vessel.
Using oil dispenser unit, flush approx. 1 liter of transmission fluid through oil lines and transmission oil cooler (refer to OPERATING FLUIDS ).
Reposition quick-release couplings.
Flush oil lines/transmission oil cooler in opposite direction with approx. 1 liter of transmission fluid (refer to OPERATING FLUIDS ).
Disconnect quick-release couplings.
Remove adapter.
Recycling:
Never use flushing oil.
Dispose of flushing oil according to country-specific waste disposal regulations.
Press hydraulic lines (1) into adapters (2).
Slide clamping bracket (3) into guides and secure with screw (4).
Arrangement of flushing device for gearbox GA8HP45Z
- Transmission oil cooler with lines
- Oil dispenser unit
17 2 015 Connection for oil dispenser unit (2), manufacturer: Deutsche Tecalemit or
17 2 016 Connection for oil dispenser unit (2), manufacturer: Horn
17 2 017 quick-release coupling (2 pieces)
17 2 019 Hose to oil dispenser unit (2)
- Oil drip tray
17 2 018 Hose to oil drip tray (3)
- Adapter with clamping bracket
17 2 080 Adapter with clamping bracket GA8HP45Z