23 11 Housing with lid
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - HOUSING WITH LID
| TRANSMISSION DESIGNATION | Type | Thread | Tightening specifications | Dimension |
|---|---|---|---|---|
| 1AZ Transmission housing, rear section/front section | B/C/D/E/F/G/H/I/7-speed SMG | 22 Nm | ||
| 2AZ Cover with guide tube/transmission case | B/C/D/E/F/G/H/I/C/7-speed SMG | M8 x 22 | 18 Nm | |
| B/C/D/E/F/G/H/I/C/7-speed SMG | M8 x 30 | 25 Nm | ||
| B/C/D/E/F/G/H/I/C/7-speed SMG | M6 | 10 Nm | ||
| 3AZ Bearing cap/sealing flange | B/C/D/E/F/G/H/I/7-speed SMG | 10.5 Nm | ||
| 4AZ Reverse gear wheel axle to intermediate housing | B/C/D/E/F/G/H/I/7-speed SMG | 49 Nm | ||
| 5AZ Retaining plate for reverse gear wheel axle to intermediate case | B/C/D/E/F/G/H/I/7-speed SMG | 25 Nm | ||
| 6AZ Transmission closing plate | B/C/D/E/F/G/H/I/7-speed SMG | M6 | 8 Nm | |
| 7AZ Transmission oil strainer in transmission | G-transmission | M18 | 25 Nm |