37 12 012 Carrying out ride height adjustment

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Ride height adjustment must be carried out after the following work:

Removal / replacement of ride height sensor or its control rod (only necessary for vehicles with air suspension or vehicles with VDC)
Replacement of wiring harness
Replacement of air supply system control unit (F01/F02/F04/F07/F11)
Replacement of vertical dynamics management control unit
Replacement of ICM control unit (Integrated Chassis Management)

Connect BMW diagnosis system.

Switch the ignition on.

Carry out ride height adjustment (menu item: "Service function").

IMPORTANT: Following ride height adjustment, for vehicles with:

Run Flat Indicator:
initialize RUN FLAT INDICATOR
Tyre Pressure Monitor: RESETTING TYRE PRESSURE MONITOR