17 11... Bleed and fill the cooling system for the charge air cooler with the vacuum filling unit: Preconditions

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

The expansion tank of the cooling system for the charge air cooler must be empty.
There must be sufficiently premixed coolant in the filling unit container, 1 - 2 liters more than the vehicle filling capacity.
- Use only recommended COOLANT .
- Observe mixture ratio: 50% antifreeze and 50% water. In severely cold areas, the antifreeze can be increased to 60% which provides freezing protection down to-62°F (-52°C). Do not exceed a 60% ratio of antifreeze.
- Observe capacities.
Position the filling unit container at the same height as the coolant expansion tank.
Compressed-air connection with 6 bar pressure present.
Set heating to maximum temperature.