LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Brakes - Repair) >> Electronic Components >> 34 52 121 Removing and installing/renewing ICM control unit >> Notes

34 52 121 Removing and installing/renewing ICM control unit: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection).

Necessary preliminary tasks: 

Open ashtray cover (1).

Fig 1: Identifying Ashtray Cover
G06890067Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Risk of damage in area (1) of center console on left and right!
Fig 2: Identifying Damage Area Of Centre Console On Left And Right
G06890068Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Installation: 

Tightening torque: see 7AZ in 51 16 MIRRORS, FINISHERS, ASHTRAYS, CONSOLES .

Fig 3: Identifying Left And Right Screws
G06890069Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on center console carrier.

Installation: 

Tightening torque: see 4AZ in 51 16 MIRRORS, FINISHERS, ASHTRAYS, CONSOLES .

IMPORTANT: Risk of damage to center console (2)!
Observe the following instruction exactly.
Fig 4: Identifying Centre Console And Screws
G06890070Courtesy of BMW OF NORTH AMERICA, INC.

Raise center console (1) at rear (A) 7 cm.

Fig 5: Identifying Centre Console
G06890071Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Picture shows center console removed.

Unfasten screws (2).

Installation: 

Replace screws.

Tightening torque: see 2AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .

Fig 6: Identifying Screws And ICM Control Unit
G06890072Courtesy of BMW OF NORTH AMERICA, INC.

Swing out ICM control unit (3).

Disconnect plug connection (1).

IMPORTANT: Do not trap any electrical leads when installing ICM control unit!