61 31 233 Removing and installing/renewing Lane Departure Warning engine electrical system (TLC actuator)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove airbag unit. See AIRBAG UNIT or AIRBAG UNIT (SPORT STEERING WHEEL) .

Remove lower steering wheel trim

Disconnect plug connection (1).

Release screws (2) and remove engine electrics (3).

Tightening torque: see 2AZ in 32 33 STEERING WHEEL .

Installation note:

Replace screws (2).

Ensure correct cable routing.

Fig 1: Identifying Engine Electrics With Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement from build date 03/2009:

Engine electrical system must be readjusted.

The service module "Adjustment actuator Lane Departure Warning" can be found at:

Body
Camera-based driver support systems
Adjustment actuator Lane Departure Warning