61 35 245 Removing and installing (replacing) Smart Opener bottom sensor line (non-contact rear lid opening)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove COVER ON REAR BUMPER PANEL

Release latch mechanisms (1) and remove control unit (2) in direction of arrow.

Fig 1: Removing Control Unit

G08509852

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock associated plug connection (1) on control unit (2) and disconnect.

Feed out connecting line from cable clips (3).

Fig 2: Identifying Control Unit, Plug Connection And Cable Clips

G08509853

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage, do not kink sensor line!

Dismantling sequence:

Detach sensor line (1) from holder (2) to the top
Detach sensor cable (1) from holder (2) to the right

Installation note:

Fig 3: Detaching Sensor Line And Cable From Holder

G08509854

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure plug connection and sensor line (1) are correctly fitted.

Make sure connecting line is correctly laid.

Brackets must not be damaged.