CBS reset in the car

On the vehicle, service operations can be reset at the instrument panel.

• there is no Check Control message
• availability of the service job is under 90 %
• on-board date must be correctly set

Resetting of a service job must always be carried out after  a maintenance measure has been completed.

The resetting process is interrupted it the time is exceeded or if a terminal is changed.

Switch the ignition on.

Press the trip distance recorder reset button (1) (referred to as button in the following) for approx. 10 seconds until the 1st service job appears in the display (2).

Bring up the next item by briefly pressing the button again. Select the desired service job.

Fig 1: Identifying Trip Distance Recorder Reset Button And Display

Courtesy of BMW OF NORTH AMERICA, INC.

If a reset is possible, this is displayed in the instrument panel as "Reset executable" (1).

Start the reset by pressing the button for 3 seconds.

Fig 2: Identifying Reset Executable

Courtesy of BMW OF NORTH AMERICA, INC.

Confirm text message "Execute reset?" (1) by pressing the button for 3 seconds again.

Fig 3: Identifying Execute Reset Button

Courtesy of BMW OF NORTH AMERICA, INC.

The status of the reset is indicated in the display by a progress bar and in text as "Reset running" (1).

Fig 4: Identifying Reset Running Display

Courtesy of BMW OF NORTH AMERICA, INC.

The reset is confirmed after completion as "Reset successful" (1).

Fig 5: Identifying Reset Successful Display

Courtesy of BMW OF NORTH AMERICA, INC.