33 32 240 Replacing a ball joint in left or right swinging arm/lower wheel carrier

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Vehicle with air suspension:
- Deactivate and drain AIR SPRING/SUSPENSION SYSTEM
- REMOVE spring strut from wheel carrier.
Vehicle without air suspension:
- Remove spring strut from wheel carrier.
Remove INTEGRAL LINK from wheel carrier.
REMOVE ANTI-ROLL BAR LINK from swinging arm.
REMOVE SWINGING ARM from wheel carrier.

Secure special tool 31 5 220 with wheel studs to drive flange.

Support axle support with special tool 31 5 220 and workshop jack 00 2 030 .

Fig 1: Supporting Axle Support Using Special Tool 31 5 220 And Workshop Jack 00 2 030

Courtesy of BMW OF NORTH AMERICA, INC.

Remove circlip (1).

Installation note:

Install retaining ring (1).

Fig 2: Identifying Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out ball joint with special tools 33 4 193 , 33 4 191 , 33 4 192 and 33 3 333 .

Fig 3: Pulling Out Ball Joint Using Special Tools 33 4 193, 33 4 191, 33 4 192 And 33 3 333

Courtesy of BMW OF NORTH AMERICA, INC.

Fit new ball joint (1) with special tools 33 3 333 , 33 4 192 , 33 4 191 and 33 4 194 .

Fig 4: Fitting Ball Joint Using Special Tools 33 3 333, 33 4 192, 33 4 191 And 33 4 194

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out wheel alignment procedure. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .