65 77 720 Removing and installing (replacing) left B-pillar sensor (older version)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Observe SAFETY INSTRUCTIONS for handling gas generators.

Incorrect handling can activate pedestrian protection and cause injury.

Necessary preliminary work:

Disconnect NEGATIVE BATTERY CABLE .
Remove TRIM PANEL FOR DOOR POST .

Release screw (1) on B-pillar (3).

Loosen screw (2).

Installation note:

Tightening torque 65 77 3AZ .

Make sure sensor is mounted without play.

Feed out B-pillar sensor in downward direction.

Fig 1: Identifying B-Pillar And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Remove B-pillar sensor (2).

Fig 2: Identifying Plug Connection And B-Pillar Sensor

Courtesy of BMW OF NORTH AMERICA, INC.