66 54 001 Axially adjusting night vision camera
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Mechanical setting - as described in the following - is only possible axially
.
Vertical alignment can only be carried out with the BMW diagnosis system:
- Service functions:
-> Driver assistance systems
-> Night vision electronics
-> Calibration night vision electronics camera
NOTE:
Installation location: Adjusting screw, Night Vision Camera F01, 02, 03:
Fold lid (1) in engine compartment lid gasket fixture mounting upwards as pictured.
NOTE:
(2) = Installation location, adjusting screw, night vision camera
NOTE:
Installation location: Adjusting screw, Night Vision Camera F07, F10, 11, 18, F12, 13:
Fold up engine compartment lid seal (1) as shown.
NOTE:
(2) = Installation location, adjusting screw, night vision camera
NOTE:
Front of vehicle must be parallel at distance (A) to headlight aiming device (1).
(A) = 2 m
Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.
Slowly carry out axial adjustment of night vision camera at adjusting screw (3).
NOTE:
Image shows the CID picture in the vehicle.
If necessary, align the image of the night vision camera with aid of a second person.
Yellow help line (1) is displayed using diagnosis job.
Upper edge (2) must be aligned using adjusting screw parallel to yellow help line (1) in the CID.