66 51 030 Remove and install/replace KAFAS camera (up to production date 07/2012)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Identifying Two-Part Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Slide camera (1) in direction of arrow out of mounting.

Disconnect plug connection (2).

Installation note:

Make sure camera (1) is firmly seated in mounting.

Fig 2: Identifying Camera And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out calibration via BMW diagnosis system:

Service functions:

Body
Lane departure warning
Calibrate camera

NOTE: A new calibration is also required when the windscreen is replaced.

NOTE: Heating of camera for lane departure warning is integrated in windscreen. If heating is defective, the windscreen must be replaced.