LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Seats - Repair) >> Rear Seat, Normal, Electric >> 52 25... Removing and installing/replacing rear panel on rear seat backrest

52 25... Removing and installing/replacing rear panel on rear seat backrest

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For purposes of clarity, the following operations are shown in the released state.

Detach cover (1) from Velcro fastener.

Pull cover (1) upwards out of guide from four-bar lever.

Fig 1: Pulling Cover Upwards Out Of Guide From Four-Bar Lever
G06895757Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure cover guide is correctly seated on four-bar lever.

Fig 2: Identifying Cover Guide On Four-Bar Lever
G06895758Courtesy of BMW OF NORTH AMERICA, INC.

Unclip rear panel at top left and right and remove in upward direction.

Fig 3: Removing Rear Panel At Top Left And Right
G06895793Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

If necessary, replace faulty clips.

Make sure guide (2) is correctly seated in backrest frame.

Fig 4: Identifying Backrest Frame Guide And Clips
G06895794Courtesy of BMW OF NORTH AMERICA, INC.