22 32 001 Replacing rubber mount for transmission mounting (ATC 35L)

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

22 1 017
22 1 041
22 1 042
22 1 043
22 1 044
22 1 046
33 4 460
33 4 466
33 4 465

Necessary preliminary tasks

Remove complete exhaust system.
Remove TRANSMISSION CROSS MEMBER.

If necessary, release screws (1) for transmission support bracket.

Tightening torque 22 32 10AZ .

Fig 1: Identifying Transmission Mounting Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks

Lower transmission with hydraulic lifting equipment.

Mount special tools 22 1 042 / 22 1 041 on transfer box.

Pull out rubber mount with thrust plate 22 1 043 by means of spindle 33 4 460 and nut 22 1 017.

Fig 2: Identifying Special Tools Mounted On Transfer Box

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pay attention to installation position of rubber mount (1).

Fig 3: Identifying Rubber Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Bolt special tool 22 1 044 to transfer box.

Insert special tool 22 1 046 with bolt into recesses of rubber mount.

Draw in rubber mount with special tools 33 4 466 and 33 4 465.

Installation note:

Auxiliary installation material - low-surface tension water.

Do not coat rubber mount with grease.

Fig 4: Drawing In Rubber Mount Using Special Tools (33 4 466 And 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

Special tools required:

22 1 017
22 1 041
22 1 042
22 1 043
22 1 044
22 1 046
33 4 460
33 4 466
33 4 465

Necessary preliminary tasks

Remove complete EXHAUST SYSTEM .
Remove transmission cross-member.

If necessary, release screws (1) for transmission support bracket.

Tightening torque 22 32 10AZ .

Fig 1: Identifying Transmission Mounting Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks

Lower transmission with hydraulic lifting equipment.

Mount special tools 22 1 042 / 22 1 041 on transfer box.

Pull out rubber mount with thrust plate 22 1 043 by means of spindle33 4 460 and nut22 1 017.

Fig 2: Identifying Special Tools Mounted On Transfer Box

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pay attention to installation position of rubber mount (1).

Fig 3: Identifying Rubber Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Bolt special tool 22 1 044 to transfer box.

Insert special tool 22 1 046 with bolt into recesses of rubber mount.

Draw in rubber mount with special tools 33 4 466 and 33 4 465.

Fig 4: Drawing In Rubber Mounting Using Special Tools (33 4 466 And 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Auxiliary installation material - low-surface tension water.

Do not coat rubber mount with grease.