64 11 216 Replacing blower for automatic rear air-conditioning system (F02 only)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove CONTROLLER FOR REAR AIR CONDITIONING BLOWER

NOTE: For purposes of clarity, the automatic rear air-conditioning system is shown in the following operations with the component removed.

Pull condensation water drain hose (1) in direction of arrow out of gaiter.

Installation note:

Condensation water drain hose must be inserted up to marking in gaiter.

Unfasten plug connection (1) and disconnect.

Snap associated plug housing out of blower cover (3).

Release screws (4).

Remove blower cover (3).

Feed out motor supply lead incl. grommet (5).

Fig 1: Removing Motor Supply Lead Incl. Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1), snap out blower motor (2) in direction of arrow and remove in upward direction.

Fig 2: Removing Blower Motor

Courtesy of BMW OF NORTH AMERICA, INC.