61 31 338 Removing and installing/replacing grip cover for gear selector switch (ceramic application, operating elements)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 322

Carefully unclip knob cover (1) 00 9 322 with special tool at points (2) from gear selector switch (3) and remove in direction of arrow.

Fig 1: Removing Gear Selector Switch Knob Cover Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove support (2).

Tightening torque 61 31 4AZ .

Fig 2: Identifying Gear Selector Switch Support And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Removed ceramic carrier (2) must not be reused.

Installation note:

Engagement lugs (1) of ceramic carrier (2) must not be damaged.

Fig 3: Identifying Engagement Lugs On Ceramic Carrier

Courtesy of BMW OF NORTH AMERICA, INC.