LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 552 (Body Equipment - Tightening Torques) >> Rear Bumper >> 51 12 Rear bumper

51 12 Rear bumper

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - REAR BUMPER

  Type Thread Tightening specifications Dimension
1AZ Support to body F01 / F02 / F03 / F04 / F06 / F12 / F13 M12 Replace nuts 66 Nm
F07 / F10 / F11 / F18 M12   108 Nm
F25     68 Nm
2AZ Guide, middle rear F01 / F02 / F03 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18   Replace nuts 4 Nm
F25   Replace nuts 4.5 Nm
3AZ Guide, side, to body F01 / F02 / F03 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18, F25   Replace nuts 4.5 Nm
Screw 3 Nm
4AZ Trailer tow hitch to bumper support        
5AZ Bumper trim panel to side fixture F07 / F10 / F11 / F18     2 Nm
F25     2.5 Nm
6AZ Bumper trim panel to rear light housing F07 / F25     4.5 Nm
F06 / F10 / F11 / F12 / F13 / F18     2 Nm
7AZ Bumper trim panel to lower centre fixture F07 / F10 / F11 / F18     4.5 Nm
8AZ Rear silencer holder F07 / F10 / F11 / F12 / F13 / F18 Nut   21 Nm
9AZ Cover on body F25 Nut   5 Nm
10AZ Bottom guide to luggage compartment floor F10 M5     4 Nm