63 12 895 Replacing drive/electronics box for left adaptive headlight

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.

Necessary preliminary tasks:

Remove WHEEL ARCH COVER (FRONT SECTION) .

NOTE: For purposes of clarity, picture shows component removed.

Release screws (1).

Remove drive/electronics box for adaptive headlight (2) from headlight (3).

Fig 1: Identifying Adaptive Headlight Drive/Electronic Box With Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When installing, make sure sealing sleeve (1) is correctly seated.

Make sure pin housing (2) is exactly seated.

Fig 2: Identifying Sealing Sleeve And Pin Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.