37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Unfasten plug connection (2) and disconnect.

Release nut (1) and disconnect jointed rod.

Tightening torque 37 14 7AZ .

Fig 1: Identifying Plug Connection And Jointed Rod Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor.

Tightening torque 37 14 5AZ .

Installation:

Sensor lever must point to front from ride-height sensor.

Fig 2: Identifying Ride-Height Sensor Nuts

Courtesy of BMW OF NORTH AMERICA, INC.