LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 390 (Collision - Body Panel Repair (E89)) >> 4163 Other Flaps >> 41 63 060 Removing And Installing Soft Top Compartment Lid

41 63 060 Removing And Installing Soft Top Compartment Lid

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work 

Close both locks by hand.

NOTE: On closing the second door lock, the Soft Close function must lock audibly.
Closing the locks is necessary so that the soft top system remains ready for operation.

Slowly close the tailgate until the tailgate locks are at the strikers.

G06910697Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Risk of damage!
A tailgate that is not properly closed can damage the soft top!
Only move the soft top with extreme caution.

Open soft top.

Stop opening procedure in the position shown.

G06910698Courtesy of BMW OF NORTH AMERICA, INC.

Open tailgate. (without operating the opener)

G06910699Courtesy of BMW OF NORTH AMERICA, INC.

Detach wiring harness (1) from tailgate and guide through soft top compartment lid.

Fig 1: Wiring Harness With Tailgate Component Location
G06910700Courtesy of BMW OF NORTH AMERICA, INC.

Carry over the work step shown symmetrically to the other side of the vehicle.

Pay attention to the spacer plates on the underside of the soft top compartment lid!

Release bolts (1) and remove soft top compartment lid in combination with the tailgate.

Tightening torque 41 62 3AZ .

Place soft top compartment lid and tailgate on a suitable surface.

G06910701Courtesy of BMW OF NORTH AMERICA, INC.

General view of underside of soft top compartment lid.

Release nuts (1) and take the tailgate off the soft top compartment lid.

Tightening torque 41 63 3AZ .

Installation note: 

G06910702Courtesy of BMW OF NORTH AMERICA, INC.