2.0 Shaping Plastic Parts

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Plastic parts can be reshaped using a hot-air blower.
Microcracks can occur in the plastic if plastic parts are deformed. After the component is reshaped and then painted, the cracks may become visible again on the surface after a period of time.
The component must be replaced if microcracks can be identified in the area of deformation.