3.1 Preparation Of Surface On Vehicle
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- Establish a level bonding surface (e.g. grinding). Do not remove primer entirely.
Do not grind/sand bonding surfaces.
- If necessary, pre-clean bonding surfaces with cavity sealing wax remover.
- Allow cleaned surfaces to dry for approx. 5 minutes.
Bonding surfaces must be completely dry.
Clean bonding surfaces with cleaning agent R1.