Setting Blind Rivets
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to repair instruction for rivet size.
- Position bore holes for blind rivets as specified in repair instruction. If necessary, carry over the positions of the rivets to the new component.
- Drill holes (0.2 mm bigger than the outside diameter of the rivet. Example 4.2 mm dia. for 4 mm rivet and 6.7 mm dia. for 6.5 mm rivet).
- Deburr holes.
- APPLY ADHESIVE .
- Insert blind rivet. If necessary, remove adhesive that has emerged.
- Rivet blind rivet with blind rivet tool. In the meantime clean rivet head if fouled with adhesive. Risk of damage to rivet head by penetrating adhesive.
- Seal blind rivets with SEALANT D1 (risk of corrosion).
- Seal cavities after painting vehicle with CAVITY SEALANT (risk of corrosion).
Position blind rivet tool vertically. Use rivet head extension if accessibility is poor.