4. Bonding
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- 4.1 Components without pre-fitted adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire adhesive area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape
- 4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire adhesive area
* Liner is the protective film on the adhesive tape