61 35 080 Removing and installing/replacing control unit/module for left or right seat adjustment

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

NOTE: Move seat completely towards rear/top.

Unlock metal lug (1) towards front and remove control unit/module for seat adjustment (2) towards bottom.

Disconnect all associated plug connections.

Fig 1: Removing Control Unit For Seat Adjustment

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure control unit/module for seat adjustment (1) is correctly seated in mounting (2).

Guides (3) and metal lug (4) must not be damaged.

Fig 2: Identifying Control Unit For Seat Adjustment, Mounting, Guides And Metal Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.