61 00... Instructions for disconnecting and connecting battery

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Observe SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY .

Before disconnecting battery

Turn off the ignition and other electrical loads/consumers to prevent sparking when reconnecting.

NOTE: If the ignition is not turned off when the battery is disconnected, fault memories may be set in some control units.

IMPORTANT:

There is a danger of mixing up battery leads: If the battery positive and negative leads are the same color and you are in doubt, follow the polarity to the battery, then mark and cover the leads.
The on-board computer and clock may lose your data.

General notes on disconnecting battery

Do not disconnect battery leads and leads from alternator and starter motor while engine is running.
Cars with IBS on battery negative terminal:
Do not under any circumstances pull/lever off pole shoes by force.

Do not under any circumstances release socket-head cap screw of IBS.
Disconnect terminal of BATTERY NEGATIVE LEAD from vehicle battery. Cover battery negative terminal(s) and secure.
When work is carried out on the electrical system, faults may be caused in the fault memories of some control units when the battery is connected.
When installing battery terminal: Tightening torque 61 21 1AZ .

After connecting battery

IMPORTANT: The scope of application of some systems may be restricted after a power supply interruption.
Likewise, individual settings may be lost.
Settings or activations must be carried out, depending on the equipment specification.
For example:

If necessary, carry out adjustment of active steering
If necessary, activate slide/tilt sunroof
If necessary, activate POWER WINDOWS

Refer to the diagnosis system for further vehicle-specific information.