61 13... Removing and installing/replacing OBD-II socket

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove FOOTWELL SIDE TRIM PANEL ON A-PILLAR, LEFT

Release screws (1).

Remove OBD-II socket (2) from holder (3).

Fig 1: Identifying Screws, OBD-II Socket And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove OBD-II socket cover (2) from OBD-II socket (1).

Unlock slide plate (3) with a suitable tool in direction of arrow.

Insert special tool 61 0 315 in OBD-II socket (1) in direction of arrow and press out associated flat spring contact (4). Press remaining flat spring contacts with special tool 61 0 315 out of OBD-II socket (1).

Fig 2: Removing Slide Plate Using Special Tool 61 0 315

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pay attention to pin assignment of OBD-II socket (1).

Make sure flat spring contacts and slide plate (3) are correctly engaged and seated in OBD-II socket (1).