CBS reset with the BMW diagnosis system
WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
To be able to check and/or correct the vehicle's on-board date properly, the BMW diagnosis system requires the correctly set tester system date!
The jobs may only be reset after the service measure has been completed.
The brake pads can only be reset with a new brake pad wear sensor.
The jobs may only be reset after the service measure has been completed.
The brake pads can only be reset with a new brake pad wear sensor.
The CBS jobs can be reset via the BMW diagnosis system on the following path:= => Perform vehicle test => Service functions => Maintenance => CBS reset