13 11 Carburetor
WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - CARBURETOR
| Type | thread | tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Carburetor to intake manifold | M10/M20/M30 | 10 Nm | ||
| 2AZ | Carburetor to insulating flange | M10/M20/M30 | 10 Nm | ||
| 3AZ | Insulating flange to intake manifold | M10/M20/M30 | 10 Nm | ||
| 4AZ | Idling shut off valve; max. | M10/M20/M30 | 5 Nm | ||
| 5AZ | Flow valve; max. | M10/M20/M30 | 28 Nm | ||
| 6AZ | Throttle valve assembly to float housing; max. | M10/M20/M30 | 9 Nm | ||
| 8AZ | Throttle valve control to carburetor; max. | 2BE | 3 Nm | ||
| 9AZ | Warm-up regulator to engine | M10/M20/M30 | 23 Nm | ||