32 41... Instructions for removing and installing ear clips

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.

To remove an ear clip, place special tool 32 1 260 at right angles to ear and cut ear open.

Fig 1: Removing Ear Clip Using Special Tool (32 1 260)

G04726374

Courtesy of BMW OF NORTH AMERICA, INC.

The ear clip can be fitted not only axially but also radially after the hook fastener has been opened.

Fig 2: Identifying Hook Fastener On Ear Clip

G04726375

Courtesy of BMW OF NORTH AMERICA, INC.

Attach hook fastener and press ear together with special tool 32 1 260.

Fig 3: Pressing Ear Clip Using Special Tool (32 1 260)

G04726376

Courtesy of BMW OF NORTH AMERICA, INC.

Side cutter of special tool 32 1 260 can be used in areas which are difficult to access.

Fig 4: Identifying Special Tool (32 1 260)

G04726377

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Gap (A) max. 1 mm!

Fig 5: Identifying Ear Clip Gap

G04726378

Courtesy of BMW OF NORTH AMERICA, INC.