LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Maintenance And General Information - Repair (N54)) >> 00 Maintenance And General Information >> 61 00... Notes on handling wiring harnesses and cables >> The following additionally applies

The following additionally applies

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Shielded lines (coaxial lines): 

IMPORTANT: Shielded lines may not  be repaired!
  • This may lead to indifferences in noise radiation and interference immunity at contact points in the shield
  • To satisfy the requirements of the type approval, it is essential to replace shielded cables completely

Fibre-optic cable: 

NOTE: Fibre-optic cables are colored differently as follows:
IMPORTANT:
  • Optical fibres may only reveal one  separation point (bridge); renew optical fibre if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid effects of heat ≤ 85°

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional BUTT CONNECTORS AND HEAT-SHRINK HOSES .

NOTE:
  • FlexRay lines may only reveal one  separation point (bride); renew complete line if necessary
  • The cable is a twisted cable. If possible, maintain twisted cable after repair